Champion Eseries - Electrical Connection

44
Initial Start-up
Check the direction of rotation of the conveyor belt by observing the direction
arrow decal on the large conveyor drive sprocket. The sprocket is located on
the side of the unload section.
If rotation direction is incorrect, reverse wires L1 and L2 on the disconnect
switch side of the main electrical connection terminal block located inside the
control cabinet.
Each temperature gauge is marked with its proper operating range.
Check the Energy Sentinel (idle pump shut-off) by placing a tray or dish on
the moving conveyor belt.
The pumps will start as the object enters the tunnel of the machine.
Theoptionalecono-rinsepumpstartswiththenalrinse.
Check pump motor rotation, CW when viewed from the rear of motor.
Installation Instructions
Initial Start-up