CHANGHE FREEDOM SERVICE MANUAL GENERAL INFORMATION
VEHICLE LIFTING POINTS
z Make absolutely sure to lock hoist after
vehicle is hoisted up.
z Before applying hoist to underbody, always
take vehicle balance throughout service into
consideration. Vehicle balance on hoist may
change depending on what part to be removed.
z Before lifting up the vehicle, check to be
sure that end of hoist arm is not in contact with
brake pipe, fuel pipe, bracket or any other part.
z When using frame contact hoist, apply hoist
as shown in figure (right and left at the same
position). Lift up the vehicle till 4 tires are a little
off the ground and make sure that the vehicle will
not fall off by trying to move vehicle body in both
ways. Work can be started only after this
confirmation.
WARNING:
When using floor jack
In raising front or rear vehicle end off the floor by
jacking, be sure to put the jack against the front end of the
engine mounting member or rear axle.
CAUTION:
Never apply jack against suspension parts
(e.g., stabilizer, etc), front bumper or vehicle floor,
otherwise, these parts may get deformed.
To perform service with either front or rear vehicle end
jacked up, be sure to place safety stands under body so
that body is securely supported. And then check to ensure
that body does not slide on safety stands and the vehicle is
held stable for safety's sake.
WARNING:
z If the vehicle to be jacked up only at the
front or rear end, be sure to block the wheels on
ground in order to ensure safety.
fter the vehicle is jacked up, be sure to
support it on stands. It is extremely dangerous to
do any work on the vehicle raised on jack alone.
10
To Next Page
Loading...
Need help?
General