CHANGHE FREEDOM SERVICE MANUAL GEAR SHIFTING CONTROL
Gear Shift Control Cable and Lever
Install by reversing procedure. Also, use care
for the following.
Washer and Bush
Be sure to install washer and bush in correct
installation position and apply SUPER GEARSE
A（99000-25010） to each gearing point indicated
in the figure below.
Cable
1. Gear select cable
When connecting shift cable and select cable
to control lever or lever in transmission case, do
not confuse their connecting position. Refer to the
figure below for correct connection.
2. Gear shift cable
10）After connecting cables, operate gear
shift control lever to check if shifts and selects
each range correctly and smoothly.
After installing all parts, check if control lever
shifts and selects each range correctly and
smoothly.
If it doesn’t, refer to MAINTENANCE
SERVICE of this section.
168
To Next Page
Loading...
Need help?
General