CHANGHE FREEDOM SERVICE MANUAL GENERAL INFORMATION
SERVICING AND HANDLING
Handle the trouble of air bag, follow the procedure of
removal and installation description in section 15.
WARNING：
z For handling and storage of a live air bag
(inflator) module, select a place where the
ambient temperature below 65 ° C (150 ° F),
without high humidity and away from electric
noise.
z When carrying a live air bag (inflator)
module, make sure the bag opening is pointed
away from you. In case of an accidental
deployment, the bag will then deploy with
minimal chance of injury. Never carry the air bag
(inflator) module by the wires or connector on
the underside of the module. When placing a live
air bag (inflator) module on a bench or other
surface, always face the bag up, away from the
surface. As the live passenger air bag (inflator)
module must be placed with its bag facing up,
this is necessary so that a free space is provided
to allow the air bag to expand in the unlikely
event of accidental deployment. Otherwise,
personal injury may result.
z The air bag (inflator) module immediately
after deployment is very hot. Wait for at least half
an hour to cool it off before proceeding the work.
z After an air bag (inflator) module has been
deployed, the surface of the air bag may contain
a powdery residue. As with many service
procedures, gloves and safety glasses should be
worn.
3
To Next Page
Loading...
Need help?
General