- Never allow muscular contraction during a stimulation session to result in movement.
You should always stimulate isometrically; this means that the extremities of the limb in
which a muscle is being stimulated must be firmly fixed, so as to prevent any movement
that results from contraction.
Warning!
- Extreme caution should be taken when in use around small children and babies!
Sucient distance to the device and its accessories is mandatory for their safety!
- Never leave the device unattended when it is switched on! Switch the device o and
disconnect the electrodes from the modules!
- After use, store the device in a safe place to avoid other people not informed to use the
device!
- This device is not a toy but a medical device where misunderstanding or misuse can
cause damage!
Warning!
Shock hazard - Strictly observe the following warnings. Failure to do so could endanger the
lives of the patient, the user and other persons involved.
- Before use allow the Wireless Professional to reach room temperature. If the unit has been
transported at temperatures below 0 °C (32°F), leave it to reach at room temperature for about 2
hours, until any condensation has disappeared.
- Electrosurgical equipment or defibrillators. Disconnect the electrodes from the device before
using electrosurgical equipment, or a defibrillator, to avoid cutaneous burns from the electrodes
and destroying the device.
- Electronic surveillance equipment. Do not apply stimulation near electronic surveillance
equipment (e.g. cardiac monitors, ECG alarms), as there is a risk they may not work properly whilst
the electrical stimulation device is being used.
- Electromagnetic radiation. Do not use the stimulator in areas in which unprotected devices are
used to emit electromagnetic radiation. Portable communications equipment can interfere with
the device.
- Cancer. Do not apply stimulation if you have progressive cancer or near any cancerous tumour.
The increased metabolism, caused by certain modes of stimulation, is likely to encourage cancer
cells to spread