10. EMC Tables
The Wireless Professional needs special EMC precautions and must be installed and started according to
the EMC information supplied in this manual.
All RF wireless transmission systems can aect the Wireless Professional.
The use of accessories, sensors and cables other than those recommended by the manufacturer may result
in stronger emissions or reduce the immunity of the Wireless Professional.
The Wireless Professional should not be used beside or stacked on top of any other equipment. If you must
use it side by side or on top of another system, you should check that the Wireless Professional works
properly in the chosen configuration
The product designation of the Wireless Professional used in the text below includes all product variants.
10.1 Electromagnetic emissions
RECOMMENDATIONS AND DECLARATION BY THE
MANUFACTURER CONCERNING ELECTROMAGNETIC EMISSIONS
The device is intended for use in the electromagnetic environment specified below.
The customer or user of the device should ensure that it is used in this environment
Emissions test Compliance Electromagnetic environment - Guide
RF emissions
CISPR 11
Group 1
The Wireless Professional uses RF energy only
for its internal operation. Consequently, its RF
emissions are unlikely to interfere with any
adjacent electrical device (radios, computers,
telephones etc.).
RF emissions
CISPR 11
Class B
Wireless Professional is suitable for use in any
establishment, other than a private dwelling or a
place connected directly to the low voltage mains
supply which powers residential buildings.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations / emission
oscillations IEC 61000-3-3
Not applicable
To Next Page
Loading...
