7.2 Behaviour of the Module LEDs
Problem Possible cause Solution
The LED blinks alternately green
and red
The module is out of range or is
not recognised by the Remote
Control.
A. Check the remote control is
properly turned on.
B. Check that the module and
the remote control are less
than 2 metres away.
C. Try restarting the module.
D. Place the module and the
remote control on the same
docking station in order to
pair them.
The LED is constantly red Module battery level low
A. Check the module is charged.
B. Try restarting the module.
C. If despite this the LED is still
red, contact the customer
services that have been
stipulated and approved by
the manufacturer.
To Next Page
Loading...
