Caution!
Equipment damage -
- Do not let the modules get in contact with massage oils or any other products of the
same type that could damaged the device or its accessories.
- Check that the voltage and frequency ratings of your local power line are those indicated
on the type plate of the power supply.
- Do not expose the Wireless Professional to direct sunlight, because some of the
components may reach unacceptably high temperatures.
- The presence of children, and pets does not normally aect the proper functioning.
However, Keep pets and children away from the product. Also, keep the unit clean and
protect it from dust and lint. The safety rules and regulations set forth apply in any case.
- It is recommended to use the transport bag that comes with the unit, for transport of the
device, and to use a proper transport box to ship it.
- Always use the AC adaptor (power supply) provided by the manufacturer to recharge the
unit.
- Do not store the modules and remote control for a long time with empty batteries.
- Only use electrodes and motor point pen supplied by the manufacturer. Other electrodes
and motor point pens may have electrical properties that are unsuitable for or may
damage the Wireless Professional.
- Size of electrodes. Do not use electrodes with an active area of less than 16 cm² due to
the risk of associated burning. Proceed systematically with caution when the density of
the current is over 2 mA/cm².
- Do not place the electrodes or pen in water.
- Do not apply solvents of any kind to the electrodes or pen.
- Skin irritation. Some people, with very sensitive skin, may experience redness under
the electrodes after a session. Generally, this redness is totally harmless and usually
disappears after 10 to 20 minutes. However, never start another stimulation session on
the same area if the redness is still visible
- Instructions for electrodes. See the usage and storage instructions displayed on the bag
of electrodes
To Next Page
Loading...
