Modules out of range
The remote control shows the out of range symbol. Shown on the channel where the problem was
detected (in this case channel 1):
Problem Possible cause Solution
No connection with modules
Modules are out of range from
Remote Control
A. Check that the module and
the remote control are less
than 2 metres away.
B. Ensure you are not in an
isolated place, without any
obstacles that may deflect
the signals from the remote
control.
C. Ensure you are in a place
that allows the signal from
the remote control to be
reflected.
D. Check the module is switched
on.
To Next Page
Loading...
