Check Point 4000 - Chapter 3 Configuring Check Point 4000 Appliances; Powering On

Check Point 4000 Appliances Getting Started Guide | 27
Chapter 3
Configuring Check Point 4000
Appliances
In This Chapter
Powering On 27
Available Software Images 28
Initial Configuration 28
Using the First Time Configuration Wizard on Gaia 29
Using the First Time Configuration Wizard on SecurePlatform 34
Creating the Network Object 38
Advanced Configuration 38
The workflow for configuring Check Point 4000 Appliances is:
1. Connect the cables and power on the appliance.
2. Use the First Time Configuration Wizard to configure the appliance.
3. Add the Check Point 4000 Appliances object in SmartDashboard and install a policy.
Powering On
To power on Check Point 4000 Appliances:
1. Connect the power cable.
2. On the back panel, turn on the Power button to start the appliance.
Note - For the Check Point 4800, when a power supply fails or is not
connected to the outlet, an alarm sounds continuously. If you hear the
alarm, replace the faulty power supply immediately, and connect the
new unit to an A/C outlet.