Check Point 4000 - License Activation; Dynamically Assigned IP; Secure Internal Communication (SIC); Configuration Summary

Configuring Check Point 4000 Appliances
Check Point 4000 Appliances Getting Started Guide | 33
Define the clients that are allowed to connect to the appliance using a web browser or SSH
client. These clients can manage the appliance using a web or SSH connection. For security
reasons, we recommend that you do not use the Any IP address option.
License Activation
If you have a license for the appliance, you can automatically add the license to the appliance.
If you need to obtain a license, visit the User Center (https://usercenter.checkpoint.com).
Select Activate later to use the limited trial license. This license is not permanent and expires.
To activate a license:
1. For a Security Gateway in a distributed configuration, enter the IP address of the Security
Management server.
2. If there is a proxy server, select Use a proxy server and enter the settings.
3. Click Activate License.
Dynamically Assigned IP
Note - You see this page when the appliance is a Security
Gateway.
A Dynamically Assigned IP (DAIP) gateway is a gateway where the external interface IP
address is assigned dynamically by the ISP.
Select this option if this Security Gateway uses dynamically assigned IP addresses.
Secure Internal Communication (SIC)
Define the Secure Internal Communication (SIC) Activation Key. The same key is used by the
gateway object in SmartDashboard.
Summary
Click Finish to complete the First Time Configuration Wizard and configure the appliance. You
can log in to the WebUI after some minutes.
Note - We recommend that you back up the system
configuration. You can use the Gaia add backup
command.