Check Point 4000 - Chapter 5 Restoring Factory Defaults; Restoring Using the WebUI

Check Point 4000 Appliances Getting Started Guide | 47
Chapter 5
Restoring Factory Defaults
In This Chapter
Restoring Using the WebUI 47
Restoring Using the Console Boot Menu 48
Restoring Using the LCD Panel 49
If necessary, restore the appliance to its factory default settings.
Important - If you restore factory defaults, all information on the
appliance is deleted.
Restoring Using the WebUI
Use the WebUI of the applicable operating system to restore the appliance to the factory
default settings. You can select one of the software images that are available on the appliance.
Gaia
Use the Gaia WebUI to restore the default factory settings.
To restore a Gaia appliance with the WebUI:
1. Open an Internet browser to the management IP address,
https://<appliance_ip_address>
2. Log in to the WebUI of the appliance using the administrator username and password.
3. In the WebUI, click Maintenance > Factory Defaults.
The Factory Defaults window opens.
4. Select the image version that you are restoring.
5. Click Apply.
SecurePlatform
Use the SecurePlatform WebUI to restore the default factory settings.