Check Point 4000 - Configuring Management DHCP; Configuring Management IP Addresses

Check Point 4000 Appliances Hardware
Check Point 4000 Appliances Getting Started Guide | 43
When Entering an IP Address
To
Press
Enter the grub menu
or
Move to the next digit
Move back to the previous digit
Approve the change
when the cursor is located on the last digit
Cancel the IP change
when the cursor is located on the first digit
Change current digit
or
Configuring Management DHCP
You can use the LCD panel to enable or disable DHCP on the management interface.
To configure management DHCP using the LCD panel:
1. Press Enter .
The panel shows Select > Network.
2. Press Enter .
The panel shows Network > DHCP.
3. Press Enter .
The panel shows that DHCP is enabled or disabled.
4. Press Up .
 If DHCP was disabled - DHCP is enabled on the management interface.
 If DHCP was enabled - DHCP is disabled on the management interface.
Configuring Management IP Addresses
You can use the LCD panel to configure these management interface IP addresses for the
appliance: