Check Point 730 - Configuring the Anti-Spam Policy

111
To configure the Anti-Spam blade:
1.
Go to Threat Prevention > Anti-Spam Blade Control.
2.
Select On or Off.
3.
Click Apply.
Configuring the Anti-Spam Policy
Your Check Point 730/750 Appliance is configured to manage a
typical Anti-Spam Policy. To change this policy, see Configuring
Anti-Spam Exceptions (on page 112).
The spam filter can identify spam emails by their source
address (default), or by email content.
To configure your appliance to inspect email content:
1.
Go to Threat Prevention > Anti-Spam Blade Control.
2.
Click Email content.
3.
Select one or more of these actions:
• Block spam emails.
• Flag spam email subject with X - Replace X with
manually defined text to add to the subject line for
spam emails.
• Flag spam email header - Identify email as spam in the
email message header.
• Handle suspected spam separately