Check Point 730 - Basic System Configuration; Threat Prevention Updates

91
CHAPTER 3
Basic System Configuration
In This Section:
Threat Prevention Updates ........................................................................................... 91
Firmware Upgrades ......................................................................................................... 92
Internet Connectivity ....................................................................................................... 93
Licensing ............................................................................................................................. 94
Backup and Restore ........................................................................................................ 95
Do these configurations after you complete the First Time
Configuration Wizard and log in to the appliance.
Threat Prevention Updates
Click the status bar at the bottom of the WebUI to see updates.
To keep your protection up to date, configure automatic
updates.
To schedule updates:
1.
Click Schedule at the bottom of the page or move the
cursor over the update status.
2.
Select the blades you want to schedule for updates.
Note - When a "Not up to date" message shows for other
blades, you must manually update them.