Check Point 730 - Setting up the Check Point 730;750 Appliance; Connecting the Cables

60
Setting up the Check Point
730/750 Appliance
1.
Remove the Check Point 730/750 Appliance from the
shipping carton and place it on a tabletop.
2.
Identity the network interface marked as LAN1. This
interface is preconfigured with the IP address 192.168.1.1.
Connecting the Cables
1.
Connect the power supply unit to the appliance and to a
power outlet.
The appliance is turned on when the power supply unit is
connected to an outlet.
The Power LED on the front panel lights up. This indicates
that the appliance is turned on.
The Alert LED on the front panel starts to blink. This
indicates that the appliance is booting up.
When the Alert LED turns off, the appliance is ready for
login.
2.
Connect the standard network cable to the LAN1 port on
the appliance and to the network adapter on your PC.
3.
If you use an external modem:
Connect the Ethernet cable to the WAN port on the
appliance back panel and plug it into your external modem
or router’s PC/LAN network port. The WAN Link LED on
the appliance front panel lights up when the Ethernet is
connected.