Check Point 730 - Configuring Check Point 730;750 Appliance; Workflow

59
CHAPTER 2
Configuring Check Point
730/750 Appliance
In This Section:
Workflow.............................................................................................................................. 59
Setting up the Check Point 730/750 Appliance ....................................................... 60
Connecting the Cables .................................................................................................... 60
The appliance is a Security Gateway and uses a web application
to manage a Security Policy. After you configure the appliance
with the First Time Configuration Wizard, the default Security
Policy is enforced automatically. Use the WebUI to configure
the software blades you activated in the First Time
Configuration Wizard and fine tune the Security Policy.
Workflow
This is the recommended workflow for configuring Check Point
730/750 Appliance:
1.
Setting up the Check Point 730/750 Appliance (on page 60).
2.
Connecting the cables (on page 60).
3.
Configuring the appliance with the First Time Configuration
Wizard.
4.
Defining a security policy with the Web User Interface
(WebUI).