Using the First Time Configuration
Wizard
Configure the Check Point 730/750 Appliance with the First
Time Configuration Wizard.
To close the wizard and save configured settings, click Quit.
Note - In the First Time Configuration Wizard, you may not see
all the pages described in this guide. The pages that show in
the wizard depend on your appliance model and the options you
select.
Starting the First Time Configuration Wizard
To configure the Check Point 730/750 Appliance for the first
time after you complete the hardware setup, use the First Time
Configuration Wizard.
If you do not complete the wizard because of one of these
conditions, the wizard will run again the next time you connect
to the appliance:
• The browser window is closed.
• The appliance is restarted while you run the wizard.
After you complete the wizard, you can use the WebUI (Web
User Interface) to change settings configured with the First
Time Configuration Wizard and to configure advanced settings.
To Next Page
Loading...
