Check Point 730 - Configuring the Anti-Spam Blade

110
Scheduling Blade Updates
The Blade Control page also shows the update status:
• Up to date
• Updated service unreachable - Usually caused by a loss in
Internet connectivity. Check your Internet connection in the
Device > Internet page and contact your ISP if the problem
continues.
• Update available / Not up to date - A new package is ready
to download but it is not time for the scheduled update.
To schedule updates:
1.
Go to Threat Prevention > Blade Control.
2.
Click Schedule Updates.
3.
Select the blades you want to update.
4.
Select the recurrence.
5.
Click Apply.
For more information on Anti-Virus Blade control options, see
the relevant
Check Point Appliance Administration Guide or the
online help from the top right-hand corner of your WebUI.
Configuring the Anti-Spam Blade
The Anti-Spam blade lets you block or flag emails that contain
spam. If you flag emails, you prevent the loss of any emails as
suspected spam. You can handle suspected spam differently.
You can also set to detect-only mode and use the logs to see if
there are spam attacks.