Check Point 730 - Guest Network; Configuring a Guest Network

127
CHAPTER 8
Guest Network
In This Section:
Configuring a Guest Network ..................................................................................... 127
Your Check Point security appliance lets you provide guest
Internet access without giving access to your local network.
When you configure a guest network with a Hotspot, you can
monitor users that connect through your guest network.
To establish a Guest Network:
• Enable a WiFi network on your appliance. The guest
network is actually a Virtual Access Point (VAP).
• Define the network interfaces that will redirect users to the
Hotspot portal when they browse from those defined
interfaces.
Configuring a Guest Network
To configure a guest network:
1.
Go to Device > Wireless.
2.
Click Guest.
3.
Select Use Hotspot.
4.
Set Wireless Security to Unprotected or Protected.
5.
In the Access Policy tab, set the access and log policy
options.