EasyManua.ls Logo

Chison ECO 3 EXPERT - Service Responsibility

Default Icon
201 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ECO 3 EXPERT Ultrasound Diagnostic System
Page 136 / 191
6. Flush all visible germicide residues from the probe and allow to air dry.
9.4 Service Responsibility
If users install, use and maintain the system fully according to CHISON’s installation manual,
operation manual and service manual, then CHISON ECO main unit has a life time of 5 years and
CHISON ECO probes have life time of 5 years after ex-work.
The warranty of the system and probes after ex-work is as the time in the warranty card.
The system is a precise electronic system. Only the CHISON’s authorized service engineer could
replace the defective parts. Any assembly, disassembly, handling, repair, or replacement by any
other people may have adverse impact on the safety and effectiveness of the systems and probes,
and thus will reduce the life time of the system and probes, and such systems and probes will not
be covered by CHISON warranty after the above improper handling. Standard maintenance must
be performed by CHISONs authorized service engineer during the life time of the product.
CAUTION: When the above life time is expired, the effectiveness and
safety of system and probes maybe greatly affected, so it’s NOT suggested to
continue using the system and probes even the system and probes seem work
properly. But if user still wants to continue using the system and probes, user should
first contact CHISON service center at CHISON headquarter to arrange the necessary
safety check and calibration by CHISON’s authorized service engineer. If CHISON
headquarter service center provides the calibration certificate for the related system or
probe, then user could continue use the system or probes according to the calibration
certificate. However, if CHISON headquarter service center concludes that the system
or probe is no longer complied to the safety and effectiveness standard, then user
should immediately stop using the system or probe. User understands that such
check and calibration cost will be born by the user.
Systems and probes keep on using after the life time may also be difficult to repair
and maintain, so it’s suggested to renew the product after the life time.

Table of Contents

Related product manuals