ECO 3 EXPERT Ultrasound Diagnostic System
Page 19 / 191
used before attempting to adjust the Acoustic Output control or any control that can affect Acoustic
Output.
Use the minimum necessary acoustic output to get the best diagnostic image or measurement
during an examination. Begin the exam with the probe that provides an optimum focal depth and
penetration.
Acoustic Output Default Levels
In order to assure that an exam does not start at a high output level, the system initiates scanning
at a reduced default output level. This reduced level is preset programmable and depends upon
the exam icon and probe selected. It takes effect when the system is powered on or New Patient is
selected. To modify acoustic output, adjust the Power Output level on the Soft Menu.
2.7 Battery Handling Instructions
CAUTION: Read and observe the following warnings and precautions to ensure correct
and safe use of Li-ion batteries.
Do not immerse the battery in water or allow it to get wet.
Do not use or store the battery near sources of heat such as a fire or heater.
Do not use any chargers other than those recommended.
Do not reverse the positive (+) and negative (-) terminals.
Do not connect the battery directly to wall outlets or car cigarette-lighter sockets.
Do not put the battery into a fire or apply direct heat to it.
Do not short-circuit the battery by connecting wires or other metal objects to the positive (+) and
negative (-) terminals.
Do not pierce the battery casing with a nail or other sharp object, break it open with a hammer,
or step on it.
Do not strike, throw or subject the battery to sever physical shock.
Do not directly solder the battery terminals.
Do not attempt to disassemble or modify the battery in any way.
Do not place the battery in a microwave oven or pressurized container.
Do not use the battery in combination with primary batteries (such as dry-cell batteries) or
To Next Page
Loading...
