Chison ECO 3 EXPERT - Image Controls

ECO 3 EXPERT Ultrasound Diagnostic System
Page 28 / 191
CAUTION: Leave enough free space from the back of the system; otherwise, with the
increasing of the temperature inside the unit, malfunction may occur.
3.5.1.5 System Positioning & Transporting
Moving the System
When moving or transporting the system, take the precautions described below to ensure
maximum safety for personnel, the system and other equipment.
Before Moving the System
 Press 3 s, system will be forced to shut down and completely switch off the system.
 Disconnect all cables from off-board peripheral devices (external printer, etc.) from the console.
NOTE:
 To prevent damage to the power cord, DO NOT pull excessively on the cord or sharply bend the
cord while wrapping it.
 Store all probes in their original cases or wrap them in soft cloth or foam to prevent damage.
 Replace gel and other essential accessories in the appropriate storage case.
 Ensure that no loose items are left on the console.
When Moving the System
 Carry the system with handle, or put the system on the cart to move it.
NOTE:
Walk slowly and carefully when moving the system.
Do not let the system strike walls or doorframe.
Transporting the System
Use extra care when transporting the system in a vehicle. After preparing the system as described
above, take the following additional precautions:
 Only use vehicles that are suitable for transport of the system.
 Before transporting, place the system in its original storage carton.
 Load and unload the system to a vehicle parked on a level surface.
 Load the unit abroad the vehicle carefully and over its center of gravity. Keep the unit still and
upright.