ii
This manual supplements the Quick Start Product
manual supplied with each instrument at the time of
shipment. Information in this installation, wiring and
operation manual is subject to change without notice.
Copyright © December 2012, Chromalox Corporation,
all rights reserved. No part of this publication may be
reproduced, transmitted, transcribed or stored in a re-
trieval system, or translated into any language in any
form by any means without the written permission of
Chromalox.
Copies of this manual are available in electronic for-
mat on the Chromalox web site (www.chromalox.com)
Printed versions are available from Chromalox or its
agents at the price published on the front cover.
Note: It is strongly recommended that applications in-
corporate a high or low limit protective device, which
will shut down the equipment at a preset process con-
dition in order to prevent possible damage to property
or products.
THE INTERNATIONAL HAZARD SYMBOL IS IN-
SCRIBED ADJACENT TO THE REAR CONNEC-
TION TERMINALS. IT IS IMPORTANT TO READ
THIS MANUAL BEFORE INSTALLING OR COM-
MISSIONING THE UNIT.
Products covered by this manual are suitable for In-
door use, Installation Category II, Pollution category 2
environments.
Products covered in this issue of the manual:
6040, 8040 & 4040 Temperature & Process Controllers,
6040, 8040 & 4040 Optional Valve Motor Drive (VMD)
Controllers, 6040 Optional Heater Break Alarm (HBA)
Controllers, 6050 & 4050 Over Temperature / Limit
Controllers.
Warranty and Returns Statement
These products are sold by Chromalox under the war-
ranties set forth in the following paragraphs. Such war-
ranties are extended only with respect to a purchase
of these products, as new merchandise, directly from
Chromalox or from a Chromalox distributor, repre-
sentative or reseller and are extended only to the first
buyer thereof who purchases them other than for the
purpose of resale.
Warranty
These products are warranted to be free from function-
al defects in material and workmanship at the time the
products leave Chromalox factory and to conform at
that time to the specifications set forth in the relevant C
instruction manuals sheet or sheets, for such products
for a period of three years.
THERE ARE NO EXPRESSED OR IMPLIED WAR-
RANTIES, WHICH EXTEND BEYOND THE WARRAN-
TIES HEREIN AND ABOVE SET FORTH. CHROMAL-
OX MAKES NO WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE WITH
RESPECT TO THE PRODUCTS.
Limitations
Chromalox shall not be liable for any incidental damag-
es, consequential damages, special damages, or any
other damages, costs or expenses excepting only the
cost or expense of repair or replacement as described
above. Products must be installed and maintained in
accordance with Chromalox instructions. There is no
warranty against damage to the product resulting from
corrosion. Users are responsible for the suitability of
the products to their application.
For a valid warranty claim, the product must be re-
turned carriage paid to the supplier within the war-
ranty period. The product must be properly packaged
to avoid damage from Electrostatic Discharge or other
forms of harm during transit.
To Next Page
Loading...
Need help?
General
