TEST ACTION APPLICABILITY
6 If there are no possible causes remaining, view repair. All
Repair
Replace and program the Sentry Key Remote Entry Module in
accordance with the Service Information.
Perform SKREEM VERIFICATION TEST - VER 1A.
7 Turn the ignition off.
Note: Visually inspect the related wiring harness. Look for any chafed,
pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?
All
Yes → Repair wiring harness/connectors as necessary.
Perform SKREEM VERIFICATION TEST - VER 1A.
No → Test Complete.
307
SKREEM
TRANSPONDER COMMUNICATION FAILURE — Continued
To Next Page
Loading...
