Symptom:
P0107-MAP SENSOR LOW
When Monitored and Set Condition:
P0107-MAP SENSOR LOW
When Monitored: Engine speed between 600 to 3500 RPM. TPS voltage less than 1.2
volts. Battery voltage greater than 10 volts.
Set Condition: The MAP sensor signal voltage is less than 0.0782 of a volt for 1.7 seconds.
One trip Fault.
POSSIBLE CAUSES
MAP SENSOR VOLTAGE BELOW .078 VOLTS
(K6) 5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
(K6) 5 VOLT SUPPLY CIRCUIT OPEN
MAP SENSOR INTERNAL FAILURE
(K1) MAP SIGNAL CIRCUIT SHORTED TO GROUND
(K1) MAP SIGNAL CIRCUIT SHORTED TO (K4) SENSOR GROUND CIRCUIT
PCM (K6) 5 VOLT SUPPLY CIRCUIT
PCM (K1) MAP SENSOR SIGNAL CIRCUIT
TEST ACTION APPLICABILITY
1 Start the engine.
With the DRBIIIt, read the MAP Sensor voltage.
Is the voltage below .078 of a volt?
All
Yes → Go To 2
No → Refer to the INTERMITTENT CONDITION symptom in the
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
2 Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Ignition on, engine not running.
Measure the voltage of the (K6) 5 Volt Supply circuit in the MAP Sensor harness
connector.
Is the voltage between 4.75 to 5.2 volts?
All
Yes → Go To 3
No → Go To 7
53
DRIVEABILITY - NGC
To Next Page
Loading...
