Symptom:
UNPROGRAMMED SKREEM
When Monitored and Set Condition:
UNPROGRAMMED SKREEM
When Monitored: With the ignition on.
Set Condition: The Sentry Key Remote Entry Module has not been programmed.
POSSIBLE CAUSES
VERIFY ACTIVE DTC
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, attempt program the SKREEM in accordance with the Service
Information.
With the DRBIIIt, erase SKREEM DTCs.
Perform 5 ignition key cycles, leaving the ignition key on for a minimum of 90 seconds
per cycle.
With the DRBIIIt, read SKREEM DTCs.
Did this DTC set again?
All
Yes → Replace the Sentry Key Remote Entry Module in accordance with
the Service Information.
No → Test Complete.
308
SKREEM
To Next Page
Loading...
