CHRYSLER SERVICE MANUAL ELECTRICAL SYSTEM—39
GUIDE
SLAVE UNIT
SWITCH W/BEZEL-
FIUER-
MOTOR
WIRING
SCREW AND WASHER
RELAY —
COUPLING
LEVER AND SHAFT
CABLE
DRIVE UNIT
SPRING
58x297
PLATE
TUBE
Fig.
43-Power Seat Assembly (Exploded View)
izontal movement. The wiring harness to motor
is looped to permit up and down movement.
The wire harness should be clipped securely
so wires will not be pinched when track is in
extreme forward position. The tracks are re-
placed only as an assembly, and are not inter-
changeable from left to right. Tracks cannot be
adjusted. The horizontal travel is five inches
and horizontal plane of seat track is inclined
11 degrees. Vertical travel is 2 inches at front
and 2 inches at rear. Available tilt is iy% de-
grees forward and 8 degrees rearward from
neutral.
72.
REMOVAL AND INSTALLATION OF
FRONT SEAT ASSEMBLY AND ADJUSTER
a. Removal
Remove front seat cushion—four-door only,
and disconnect battery. Remove control wires
from switch. Remove front seat assembly. On
Hard-Top-Models—remove front seat and cush-
ion as an assembly. Remove nuts from seat
guide attaching studs and remove adjuster
from car.
NOTE:
Do not damage flexible tubing during
removal.
b.
Installation
Install adjuster and attaching nuts. Connect
seat adjuster battery wire to circuit breaker
in cowl. Allow loop from relay to clip on floor
for horizontal travel. Install front seat assem-
bly. Connect control wires to switch and install
front seat cushion on four-door models.
58x190
Fig.
44—Removing Left Guide and Drive Assembly
MyMopar.com
To Next Page
Loading...
