CHRYSLER SERVICE MANUAL
BODY AND SHEET METAL—25
When installing quarter window, slide seal
and lower channel on glass. Wind regulator
arm up until the end protrudes above window
opening. Connect arm to lower channel. Guide
glass in rear portion of glass run channel and
carefully lower glass. Install top and forward
portion of felt run channel. Make certain that
upper and lower side clips are engaged when
front portion of felt run channel is installed.
Refer to c, below, for adjustment of rear quar-
ter window. Install trim panel and the other
components that were removed.
b.
Convertible Coupe
Lower top, position quarter window, and re-
move retainer and washer that holds regulator
arm to lower glass channel. Remove pivot
bracket hinge screws, (see Fig. 59). Work win-
dow assembly up and out of quarter panel.
When installing quarter window, make sure
regulator arm-to-lower glass channel is in-
stalled correctly and is secure. Complete re-
mainder of installation operations.
c. Adjustment of Rear Quarter Window
The rear quarter window can be adjusted in or
out by use of four adjusting screws threaded
into pivot bracket, (see Fig. 59). The rear of
window can be adjusted in or out by adjust-
ments located at top and bottom of guide track.
Upward travel of window is controlled by an
DOOR HANDLE SPRING
(1
EACH SIDE)
DOOR HANDLE RETAINER PLATE
.REAR GLASS RUNX
I ATTACHING SCREWS
4
FRONT GLASS
RUN
ATTACHING SCREWS
UPPER
STOP SCREWS
REGULATOR
ATTACHING
SCREWS
LOWER PANEL RETAINING BRACKETS
57x672
Fig.
59—Rear Quarter Window Adjustment (Club
and Convertible Coupe)
BUMPER
57x669
Fig.
60—Removing
or
Installing Door Handle
adjustable stop located at the rear of window.
Downward travel is controlled by a non-ad-
justable stop in reinforcement of pillar post.
24.
REMOVAL AND INSTALLATION OF
OUTSIDE DOOR HANDLE (All Models)
The combination push-pull type door handle is
used on all models. The handle attaching screw
is accessible from inside of door handle opening
(Fig. 60). Remove remote control handle gar-
nish moulding (if so equipped). Remove trim
panel and arm rest assembly. Remove lock as-
sembly attaching screws. Remove access plug
in door (Fig. 61) and remove handle to lock
attaching link screws. Lift door handle slight-
ly, and slide handle from door opening, as
shown in Figure 60. Assemble handle, trim
panel components and remote control handle
in the reverse of disassembly.
Do not damage finish of handle when in-
stalling. Check body of handle for burrs on
edges and use a copper or aluminum chafing
pad to protect finish. Apply small amount of
lubriplate to handle actuator, and carefully
slide handle into place. Install attaching nuts,
connect lock strap, check handle for proper op-
eration and tighten strap attaching screw.
25.
REMOVAL AND INSTALLATION OF DOOR
LOCK CYLINDER (All Models)
a. Removed
Remove the door trim panel and arm rest as-
sembly and remote control handle. Remove the
MyMopar.com
To Next Page
Loading...
