CHRYSLER SERVICE MANUAL
ENGINE—31
FILTER SHELL
SHELL GASKET
FILTER ELEMENT
-(CARTRIDGE)
MOUNTING BOLT
•LOCKWASHER
OIL FILTER BASE
/ to/
MOUNTING GASKET
ha:/
^~
y
51x715A
Fig.
57-Full Flow Type Oil Filter (Disassembled View)
Figure 49. Align tank on oil pump shaft with
slot on distributor lower drive shaft. Install
oil pump to rear main bearing cap. Tighten
mounting bolts to 33 foot-pounds torque.
After oil pump has been installed, check
alignment of strainer. The bottom of strainer
must be on a horizontal plane with machined
surface of cylinder block. The foot on the
strainer should touch bottom of oil pan.
38.
REMOVAL AND INSTALLATION OF
OIL FILTER
Remove the shell retaining center bolt and lift
off outer shell and gasket. (Fig. 57). Remove
filter element. Remove filter base attaching
bolts and filter base if necessary.
Use new gaskets, reinstall filter base and new
\
Fig.
58-lnstalling Rear Main Bearing Oil Seal
filter element. Install outer shell and tighten
center bolt securely.
NOTE:
FirePower Engine—Remove air clean-
er.
Loosen oil filter. Raise car. Remove filter
from below car.
39.
REPLACEMENT OF REAR MAIN BEARING
OIL SEAL (Crankshaft removed)
Remove old oil seals from cylinder block and
bearing cap. Install a new rear main bearing
oil seal in block so that both ends protrude.
Tap seal down into position using Tool C-3574
on the FirePower Engines and Tool C-3020 on
the SpitFire Engines until tool is seated in
bearing bore. Hold tool in this position, and
cut off portion*bf seal that extends above block
on both sides.
Install a new seal in bearing cap (bearing
shell removed) so that the ends protrude. (Fig.
58.) Tap seal down into position with Tool C-
3511 (left-hand view), until tool is seated. Trim
off portion of seal that protrudes above cap
(right-hand view). Install two cap side seals
in grooves in cap. Care should be used when
installing these seals as they are NOT inter-
MyMopar.com
To Next Page
Loading...
