CHRYSLER SERVICE MANUAL
TOROUE-FLITE TRANSMISSION—43
remove hand brake support and shoe assem-
blies from extension to replace output shaft
rear bearing.
b.
Installation
With guide studs, Tool C-3283 installed in
transmission case, install a new extension gas-
ket over guide studs and into position against
output shaft support. Do not use sealing ma-
terial on gasket. Using extreme care, place ex-
tension and hand brake assembly over output
shaft and on guide studs. Due to interference
of the insulator, it will be necessary to start
the bottom extension to case screw as the ex-
tension is pushed into position against support.
Do not use hammer or attempt to pull exten-
sion in with the aid of screws: otherwise, dam-
age to extension may result. The propeller shaft
flange and drum assembly may be used to force
bearing in extension on output shaft.
Remove guide studs, Tool C-3283 and install
six remaining extension to case screws and
lockwashers. Draw down evenly and tighten
to Data and Specifications. After screws have
been properly tightened, turn output shaft to
make sure it turns freely. Lower transmission
and at the same time align mounting studs in
insulator with holes in crossmember. Install
nuts and lockwashers and tighten to specifica-
tions.
Engage ball end of hand brake cable in
operating lever and tighten cable clamp bolt.
Install propeller shaft flange and drum as-
sembly, washer, and nut. Apply hand brake
or using Tool C-3281 to hold flange, tighten
nut to Data and Specifications. Install adjust-
ing screw cover plate on hand brake support.
Connect front universal joint and tighten to
specifications. Install speedometer pinion and
sleeve assembly. Tighten to specifications and
connect speedometer cable and housing. Lower
vehicle and refill transmission to proper level
with Automatic Transmission Fluid (Type A).
Refer to Lubrication Section.
32.
GOVERNOR
a. Removal
Remove governor locating screw from gover-
screw driver, remove the governor valve shaft
snap ring from the weight assembly end. Re-
move governor valve shaft and valve from gov-
ernor body assembly (Fig. 33).
GOVERNOR VALVE
AND SHAFT
SUPPORT TO TRANSMISSION CASE SCREW-;
• ^ ^;
n
m, *'56x664^
Fig.
33—Removal and Installation of Governor
Valve Shaft and Valve
Using Tool C-3229, remove governor weight
assembly snap ring (large) and remove gov-
ernor weight assembly from governor body.
The primary cause of governor operating
failures is due to improper operation of gov-
ernor valve which may be sticking in housing
or travel restricted by chips or other foreign
matter. If inspection reveals necessity for fur-
ther governor servicing, then remove governor
support locating screw, and remove governor
and support assembly from rear oil pump hous-
VERNOR BODY AND SUPPORT
Fig.
34—Removal and Installation of Governor Body
and Support Assembly
MyMopar.com
To Next Page
Loading...
