CHRYSLER SERVICE MANUAL
TORQUE-FLITE TRANSMISSION—39
SERVICING
OF
COMPONENT PARTS WITH
TRANSMISSION
IN
VEHICLE
22.
SPEEDOMETER PINION
a. Removal
Disconnect speedometer cable
and
housing from
drive pinion
and
sleeve assembly. Remove
speedometer pinion
and
sleeve assembly from
transmission extension. Refer
to
Page
87 for
Speedometer Pinion Usage Chart.
b.
Installation
Install speedometer pinion
and
sleeve assembly
in transmission extension
and
tighten
to
speci-
fications.
23. NEUTRAL STARTING SWITCH
a.
Removal
Drain approximately two quarts of fluid from
transmission by disconnecting filler tube at oil
pan connector, (may be necessary to loosen
filler tube support bracket screw). Remove wire
at switch. Remove switch.
b.
Installation
Refer
to
Paragraph
14.
24.
TRANSMISSION REGULATOR
VALVE ASSEMBLY
a. Removal
Remove transmission regulator valve adjusting
TRANSMISSION REGULATOR
VALVE
PIECE
OF
WELDING
ROD
53x55
Fig.
28—Typical View—Showing Method
of Removing Regulator Valve
screw and lock nut, gasket, cup, spring and
sleeve. Using a mechanical retriever or a piece
of welding rod
(%2
/r
)
inserted in end of valve,
remove valve (Fig. 28).
b.
Installation
With
the
assistance
of the
retrieving tool, place
valve
in
position
and
seat properly
in
regulator
valve body. Install regulator valve spring,
sleeve,
cup,
gasket, adjusting screw
and
lock
nut
and
tighten
to
specifications. Check line
pressure
and
adjust
if
necessary.
25.
TORQUE CONVERTER CONTROL
VALVE ASSEMBLY
a.
Removal
Remove
the
torque converter control valve
spring retainer
(Fig. 22)
gasket
and
spring.
Using
a
mechanical retriever
or a
piece
of
welding
rod (Vs")
inserted
in end of
valve,
remove valve.
b.
Installation
With
the
assistance
of the
retrieving tool, place
valve
in
position
and
seat properly
in
regulator
valve body. Install torque converter control
valve spring, gasket,
and
retainer,
and
tighten
to specifications.
26.
OIL PAN
a. Removal
Drain transmission by disconnecting filler tube
connector at oil pan. (It may be necessary to
loosen filler tube support bracket screw.) Re-
move the oil pan screws and washers, and re-
move the oil pan and gasket from transmission
case.
b.
Installation
Using a new oil pan gasket, place oil pan into
position on transmission case. Install oil pan
screws and washers drawing them down evenly
and tighten to specifications. Install oil pan
filler tube, and tighten nut connector to speci-
fications. Tighten support bracket screw. Re-
fill transmission with Automatic Transmission
Fluid (Type A). Refer to Lubrication Section.
MyMopar.com
To Next Page
Loading...
