CHRYSLER SERVICE MANUAL
BODY AND SHEET METAL—75
applying sealer. Remove spots with an art gum
eraser and brush off dust and road dirt with
a whisk broom. Using a sponge or brush, wash
top thoroughly with warm water and mild
soap.
Scrub top with soap suds, starting in cen-
ter and gradually working toward edges. When
top is clean, wipe off excess suds with a clean,
wet cloth. Allow top to dry and apply sealer
evenly with a brush.
Before lowering top, make sure the fabric is
completely dry. Dampness may cause formation
of mildew and damage to the fabric will result.
SERVICING THE TOWN AND COUNTRY WAGON
For information relative to servicing of the
Town and Country Wagon engine, transmission
and axle components other than the tail gate,
rear quarter panel and windows, refer to the
Section covering these items in this Manual.
To service the tail gate and rear quarter
window, refer to Figure 151 and proceed as
follows:
SERVICE PROCEDURES
65.
TAIL GATE
a. Removal
To remove the tail gate proceed as follows:
NOTE:
On electric operated models, disconnect
battery ground cable and wiring at tail gate.
Lower tail gate glass, open tail gate so that tail
gate is in straight up position.
WEATHERSTRIP
TORSION RODS (REMOVED)
Remove the four screws and hinge at each
end (Fig. 151) (body half of hinge), remove
tail gate as an assembly.
b.
Installation
Position tail gate straight up on body. Install
hinge, attaching screws, but do not tighten se-
curely. Align and adjust position of tail gate
RETAINING RING
POWER WINDOW.
LIFT MOTOR
RETAINER WASHER
REGULATOR
ARM
CENTER ANCHOR (REMOVED)
"WINDOW STOP#/C*
iADJUSTING BOLTS
(LOWER
REGULATOR ASSEMBLY
REGULATOR
ARM
RETAINER WASHER
/TAIL GATE
HELICAL
ROTOR
WINDOW STOP ADJUSTING BOLTS (UPPER)
57x618A
Fig. 151—
Tail Gate Assembly
MyMopar.com
To Next Page
Loading...
