CHRYSLER SERVICE MANUAL
TORQUE-FLUE TRANSMISSION—85
Dowel Offset
(inches)
.007
.014
.021
Part Number
1736347
1736348
1736353
In the case, under consideration, use of the
.007 inch offset dowels (pair) will bring the
runout well within the allowable limit of .005
inch,
or: .008 inch minus .007 inch (offset
dowels) equals .001 inch runout. Dowels must
be used in pairs (same part number).
To install the dowel pins (pair), remove the
torque converter housing* as outlined in Para-
graph 132 (a). Remove dowel pins from adapt-
er plate, as shown in Figure 122.
Select eccentric dowels (pair) as indicated
in Eccentric Dowel Chart.
Fig.
123—Checking Face Runout (Typical View-
Housing for Air Cooled Converter Shown)
ECCENTRIC DOWEL CHART
Total Indicator
Reading
.012*
to .020"
.022*
to .034"
.036"
to .052"
One-Half Total
Indicator Reading
.006*
to .010"
.011"
to .017"
.018"
to .026"
Size Dowel
to be Used
.007"
.014"
.021"
Dowel Part
Number
1736347
1736348
1736353
Install both dowels with the slots parallel
and aligned in the direction to correct the bore
runout. (Slot indicates the direction of max-
imum dowel eccentricity.) Majority of correc-
tions will be for one direction only; but it is
possible that the housing bore may be out in
two directions. In the latter case, it may be
necessary to use the next higher step dowels,
adjusting these dowels with the housing in-
stalled to bring within tolerance. Care should
be taken to back up adapter plate when insert-
ing lower dowel to avoid distortion or breakage
of adapter plate. Both dowels should be inserted
into adapter plate up to off-set shoulder.
Install and tighten converter housing bolts
to 50 foot-pounds torque. Remount dial indi-
cator and recheck bore runout. Small correc-
tions can be made by loosening housing mount-
ing bolts and turning dowels with a screw
driver to shift the housing and bring bore
within limits.
b.
Face Runout
Relocate dial indicator set, Tool C-3339, as
shown in Figure 123. Rotate converter as out-
lined in Paragraph 3 (a-3). If the total indi-
cator reading is greater than .008 inch note the
amount of the total indicator reading and the
location of the lowest indicator reading (i.e.,
the point where the indicator arm or follower
is extended the furthest).
Place the shim or shims on one or more of
the transmission to housing bolts in position
Part Number
1610442
1610443
1610444
Thickness
.002"
.003"
.005"
MyMopar.com
To Next Page
Loading...
