10—BODY AND SHEET METAL
CHRYSLER SERVICE MANUAL
Fig. 21
—Vent Frame and Division Bar Assembly
b.
Vent Window Frame Adjustment
Adjust the vent frame and division bar assem-
bly in or out at three attaching points. Loosen
the upper frame attaching bolt from the front
face of the door, as shown in Figure 21.
Loosen the lower frame attaching bolt at the
bracket inside the inner panel. Loosen the bolt
that holds the lower end of the division bar to
its bracket inside the door, move the frame in
or out for a good fit and seal. Tighten the three
attaching bolts and check the over-all fit by
opening and closing the door.
c. Front Door Glass Adjustment
Raise the front door glass and see if it forms
a straight line with the top edge of the vent
frame. If you need to level the glass, loosen
the cross-arm pivot shaft nut and the upper
glass stops. Loosen the small bolt that holds
the division bar bracket, as shown in Figure 22.
58x21
Fig.
23—Leveling the Glass and Rear Channel
Raise the glass all the way, and shift it by
hand so the top edge is level. Hold it in that
position, and retighten the bolt, the pivot shaft
nut, and the upper glass stops. Check glass op-
eration again. If it runs too tightly, or too
loosely in the channels, adjust the rear channel,
as shown in Figure 23.
Loosen the bolts of the two brackets that
hold the rear run channel. Lower the glass and
shift the rear channel forward until it makes
even contact with the rear edge of the glass.
Tighten the brackets to hold the adjustment as
shown in Figure 24.
d. In-Or-Out Glass Adjustment at the Rear
Edge of the Door
Loosen the two rear run-channel-to-bracket at-
taching bolts from the rear face of the door.
Move the glass in or out as needed. Tighten
the rear channel bolts. Check glass fit at the
Fig.
22—Front Door Glass Adjustment
(4-Door Hardtop)
58x23
Fig.
24—Adjusting Rear Run Channel
MyMopar.com
To Next Page
Loading...
