CHRYSLER SERVICE MANUAL
BODY AND SHEET METAL—57
On the movable type vent, determine if the
compression of the weatherstrip is adequate.
If not, it must be adjusted with the quarter
window assembly out before it is installed. Re-
move the garnish mouldings and remove the
rear quarter window assembly.
On Saratoga, New Yorker, and Imperial four-
door sedans, remove the extruded aluminum
roof rail mouldings. CAUTION: Do not attempt
to remove the painted rear quarter window
mouldings on the Windsor sedan. Seal between
the extruded aluminum moulding and the roof
rail and the junction of the end of the moulding
to the rear quarter panel (Fig. 128). Seal be-
tween the extruded aluminum moulding and
the front edge of the quarter window frame
(upper portion of "C" pillar). Install the ex-
truded aluminum mouldings. Pack all three
MOULDING
WEATHERSTRIP
58x105
VIEW IN DIRECTION OF
ARROW "A" FROM
INSIDE OF BODY
OUTSIDE MOULDING
OUTSIDE MOULDING
VIEW IN DIRECTION OF
ARROW "C" FROM
INSIDE OF BODY
1/4 DIA. PUNCH 2 HOLES
IN TROUGH
QUARTER PANEL
LOCK PILLAR
UPPER
TO <£ OF BODY
TO <£ OF BODY
VIEW IN DIRECTION OF ARROW "B"
FROM INSIDE OF BODY
58x106
Fig.
129—Rear Quarter Window Opening
MyMopar.com
To Next Page
Loading...
