CHRYSLER SERVICE MANUAL
BODY AND SHEET METAL—63
the weatherstrip. On Imperial bodies apply
sealer, as shown in Figure 137. On bodies hav-
ing license inserts, seal around the license
frame mounting retainers with body caulking
putty. Seal the deck lid at the lifting handle
attaching screws. Seal around license lamp by
reseating and sealing the gasket.
On the Imperial models having a simulated
spare tire cover on the luggage compartment
deck lid, seal around each moulding attaching
bolt nut with body caulking putty. If the seam
joint between the outer periphery of the cover
and the deck lid is leaking, seal with liquid body
sealer from the inside. (In some instances it
may be necessary to remove the moulding and
seal this seam joint from the outside.) Seal
around the periphery of the hub cap (Fig. 138)
with clear liquid sealer.
Seal all openings and joint seams on the in-
side of the luggage compartment lower panel,
especially the back-up lamp wire grommets.
Seal all luggage compartment floor panel seams
with liquid body sealer (Fig. 139). Seal between
the luggage compartment lower panel and floor
panel with black mastic sealer.
'CEMENT
•A"
BODIES
SEALER
•B"
BODIES
58x113
Fig. 136—
Luggage Compartment
MyMopar.com
To Next Page
Loading...
