To Next Page

To Previous Page

Update

Chapter 5

Applying Formats for Data Editin

5.2.1 SELECT FORMAT TO CONFIGURE

Start Programming Format

Select one editing format (Format 1~3) and the parameters pertaining to the editing format can

then be configured – applicable code type, data length, matching string & location, total number of

fields, field settings (field-dividing rule), additional fields, and field transmission sequence.

 Up to three different formats can be specified.

Configure Format 1

Configure Format 2

Configure Format 3

Note: Before you complete the programming of an editing format, if you have the

scanner read any barcode for parameters other than those pertaining to the

editing format, it will automatically abort the programming process.

End Programming Format

After having configured all the desired parameters, you must have the scanner read the “End

Programming Format” barcode, which can be located at the bottom of every even page in this

chapter.

End Programming

Format

CipherLab 1000 User Manual

Questions and Answers: