25
Update
Chapter 1
Understanding the Barcode Scanner
1.8 AUTO-SENSE MODE (1100 ONLY)
This mode is only available when you want to seat the scanner in the Auto-Sense Stand.
When you enable this mode, it will force the scanner to apply Laser mode as the scan
mode. However, it works slightly different from the original Laser mode. Now the scanner
will be scanning as long as it is seated in the stand. Whenever a barcode is brought
within range, the scanner will be able to decode it.
Note: Auto-sense can only be enabled for CCD scanner and will force it to Laser mode.
Enable
*Disable
Warning: When you disable this mode later, the scan mode remains unchanged. If
Laser mode is not desired, proceed to select a scan mode best suits your
application.
1.9 NEGATIVE BARCODES
Normally, barcodes are printed with the color of the bars darker than that of the spaces.
But for negative barcodes, they are printed in the opposite sense just like negative films.
The spaces of negative barcodes are printed with a color darker than that of the bars.
You can configure the scanner to be able to read negative barcodes.
Enable
*Disable
To Next Page
Loading...
Need help?
General
