83
Update
Chapter 4
Defining Output Format
4.2 PREFIX/SUFFIX CODE
By default, there is no prefix code, and [ENTER] or [CR] (Carriage Return) is configured
to be suffix code. Up to 4 characters can be configured, for example, “[$][$][$][$]”, and
you will have four dollar signs appear in front of the barcode read, like this –
“$$$$1234567890”.
If “Keyboard Wedge” is configured for interface, Key Type and Key Status will then
become applicable. You may decide whether or not to apply Key Status when “Normal
Key” is selected for Key Type.
Key Type
Key Status
Scan Code Up to 2 scan code values are
allowed.
N/A
Normal Key Up to 4 character strings are
allowed.
Add Shift
Add Left Ctrl
Add Left Alt
Add Right Ctrl
Add Right Alt
Refer to
Keyboard Wedge Table.
Configure Prefix
Configure Suffix
1) Read the barcode above to apply prefix code or suffix code separately, and follow
steps 2~3. (Max. 4 characters each)
2) Read the “
Hexadecimal Value” barcode on page 128 for the desired character string.
For example, read “2” and “B” for the scanner to prefix or suffix the character [+].
3) Read the “Validate” barcode to complete this setting.
To Next Page
Loading...
Need help?
General
