Using Reader Configuration Utility
Sets the intercharacter gap size for Code 39 and Codabar. This option is to
allow the digital scanner to adjust its decoding standard so as to tolerate
out-of-specification bar codes that are improperly printed out (which may
cause the intercharacter size to become larger). Switch between Normal
and Large.
Sets the reader’s scanning behavior.
Level Mode: The decoding process is activated by a trigger event, and
continues until the trigger event ends, a valid decode happens or decode
session time-out is reached.
Release Scan Mode: Keep pressing the scan key to project the aiming
pattern, and the decoding process is not triggered till the scan key is
released.
Aimer Mode: Press the scan key once to project the aiming pattern, and
then press the scan key again (before the aiming pattern fades) to trigger
the decoding process.
Level and Aim Mode: Press the scan key once to project the aiming
pattern and then press again to decode. The aiming pattern remains after
successfully decoding, and the reader is ready to decode by pressing the
scan key again.
A time period that the aiming pattern is projected for Aimer Mode.
This function is only available when setting Scan Mode as Aimer Mode
or Level and Aim Mode.
Enables an LED light beam to aid barcode reading.
Projects a crosshair at the center of the laser light beam to facilitate
barcode reading.
When selected, only barcodes aligned at the crosshair of the laser light
beam will be decoded.
Enable improved performance for reading barcodes on electronic displays
and mobile phones.
Decide whether to disable or enable decoding inverse barcodes, or set as
auto.
Functions when “auto-discriminate” is applied for UPC/EAN addons.
Decides the number of times of supplemental decoding of the same
barcode in order to count as a valid read. Configurable between 2 and 30.
Users can adjust the illumination brightness of the LED light source. Move
the slider to specify a value ranging from 1 to 10 to set the brightness
level which is set to 10 by default meaning 100% illuminated.
Sets whether to include AIM code ID character in the decoded data. For
AIM code ID, see the following:
Code 128 Emulation of 2D Imager Symbology Settings.
To Next Page
Loading...
Need help?
General
