Circutor CVM-C4 Series - Device Installation; Prior Recommendations

8
CVM-C4
Instruction Manual
3 �- DEVICE INSTALLATION
3.1.- PRIOR RECOMMENDATIONS
In order to use the device safely, it is critical that individuals who handle it follow
the safety measures set out in the standards of the country where it is being
used, using the personal protective equipment necessary (rubber gloves, face
protectionandapprovedame-resistantclothing)topreventinjuriesduetoelec-
tric shock or electric arc as a consequence of exposure to current-carrying con-
ductors and paying attention to the various warnings indicated in this instruction
manual.
The CVM-C4 devicemustbeinstalledbyauthorisedandqualiedstaff.
The power supply plug must be disconnected and measurement systems switched off before
handling, altering the connections or replacing the device. It is dangerous to handle the device
while it is powered.
It is critical to keep wires in perfect condition to avoid accidents, personal injury or damage to
installations.
Limittheoperationofthedevicetomeasuringthespeciedcurrentorvoltagevalues.
The manufacturer of the device is not responsible for any damage resulting from failure by the
user or installer to heed the warnings and/or recommendations set out in this manual, nor for
damage resulting from the use of non-original products or accessories or those made by other
manufacturers.
Do not use the device to take measurements if you detect an anomaly or malfunction.
Disconnect the device from the mains and from the power supply (both the device
and its measuring system) before performing any maintenance work, repairs or
handling any of the connections of the device.
Contact the after-sales service if you detect that the device is not working prop-
erly.