Cisco Firepower Management Center 1600, 2600,
and 4600 Getting Started Guide
First Published: 2019-06-26
Last Modified: 2022-05-31
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
The Firepower Management Center 1600, 2600, and 4600 Getting Started Guide explains installation, login,
setup, initial administrative settings, and configuration for your secure network. This document also describes
maintenance activities such as establishing alternative means of management center access, adding managed
devices to the management center, factory reset, saving and loading configurations, erasing the hard drive,
and performing shutdown or restart.
In a typical deployment on a large network, you install multiple managed devices on network segments. Each
device controls, inspects, monitors, and analyzes traffic, and then reports to a management center. The
management center provides a centralized management console with a web interface that you can use to
perform administrative, management, analysis, and reporting tasks in service to securing your local network.
About the Firepower Management Center Models 1600, 2600, and 4600
The following topics provide information about front and rear panel features that you need to follow the
instructions in this document.
Rear Panel Features
The following figure illustrates the rear panel of the Firepower Management Center 1600, 2600, and 4600.
For more information on the rear-panel features, see the Cisco Firepower Management Center 1600, 2600,
and 4600 Hardware Installation Guide.
Figure 1: Rear Panel
USB 3.0 Type A (USB 2)
You can connect a keyboard, and along with a
monitor on the VGA port, you can access the
console.
2USB 3.0 Type A (USB 1)
You can connect a keyboard, and along with a
monitor on the VGA port, you can access the
console.
1
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
1
To Next Page
Need help?
General
