Index
IN-2
Software Configuration Guide For Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-04
show controllers 3-29
show controllers atm 3-26
show ima interface atm 3-26
show interface async 3-28
show interfaces 3-29
show line 3-28
show protocols 3-29
show running-config 3-29
show version 3-29
stack C-5
sysret C-5
tftpdnld C-4
undo 1-14
xmodem C-8
compress command 3-49
compression
hardware 3-49
PPP 3-49
configuration
before starting router 2-1
completing 2-23
global parameters 2-2
saving 2-23
timeout 3-2
verifying 3-29
voice over IP 4-2
voice over IP examples 4-3
configuration, saving 1-15
configuration example A-23
configuration register
changing settings C-5
configuration tasks 3-51
configure modem lines for dial-in and dial-out 3-57
configure the modem for dial-in 3-57
configure the modem for dial-out 3-57
configure the default IP pool information 3-57
configure the E1/T1 network module for ISDN
PRI 3-51
configure channelized E1 ISDN PRI 3-51
configure channelized T1 ISDN PRI 3-52
configure the ISDN D-channel serial interfaces 3-53
configure the ISDN D-channel serial interface for E1
modules 3-53
configure the ISDN D-channel serial interface for T1
modules 3-54
configure the ISDN dialer interface 3-56
configure the LAN interface 3-55
configure the loopback interface 3-54
create the group asynchronous interface 3-55
configuring
analog modem 3-26
asynchronous/synchronous serial interface 3-5
asynchronous interface 3-9
ATM interface 3-20
PVCs 3-20
SVCs 3-21
country codes 3-28
E1 interface 3-14
Ethernet interface 3-3
global parameters 2-2
high-density voice interface
codec complexity 3-17
IMA interface 3-22
ATM T1/E1 interface 3-23
IMA group interface 3-24
interface parameters 2-5
ISDN-BRI interface 3-10
ISDN BRI line 2-15
ISDN PRI interface 3-14
E1 interface 3-16
T1 interface 3-15
multiflex trunk interface 3-14
E1 interface 3-16
T1 interface 3-15
TDM connect 3-16
T1 (FT1) WAN interface 3-18
T1 interface 3-14
context command C-5
To Next Page
Loading...
Need help?
General
