Cisco 2620 User Manual

2-6
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-04
Chapter2 Using the Setup Command Facility
Configuring Interface Parameters
• Serial Interface Configuration, page 2-7
• Asynchronous/Synchronous Serial Interface Configuration, page 2-9
• ISDN BRI Interface Configuration, page 2-12
• E1/T1 ISDN PRI Configuration, page 2-17
– E1/T1 PRI Mode, page 2-17
– E1 Channelized Mode, page 2-18
– T1 Channelized Mode, page 2-20
• 1-Port, 4-Wire 56-kbps DSU/CSU Configuration Setup, page 2-22
When you complete the setup steps for your interface modules, go to the “Completing the
Configuration” section on page2-23 for directions on saving your configuration.
Ethernet Interface Configuration
This section contains a sample configuration for the Ethernet interface. Enter the values appropriate for
your router and network. The messages you see may vary.
Do you want to configure Ethernet0/0 interface [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 255.255.255.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 1.0.0.0, 8 subnet bits, mask is /8
Configure IPX on this interface? [no]: y
IPX network number [1]:
Need to select encapsulation type
[0] sap (IEEE 802.2)
[1] snap (IEEE 802.2 SNAP)
[2] arpa (Ethernet_II)
[3] novell-ether (Novell Ethernet_802.3)
Enter the encapsulation type [2]:
FastEthernet Interface Configuration
This section contains a sample configuration for the FastEthernet interface. Enter the values appropriate
for your router and network. The messages you see may vary.
Do you want to configure FastEthernet0/0 interface [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [no]: yes
IP address for this interface: 6.0.0.1
Number of bits in subnet field [0]:
Class A network is 6.0.0.0, 0 subnet bits, mask is /8
Configure IPX on this interface? [yes]:
IPX network number [1]:
Need to select encapsulation type
[0] sap (IEEE 802.2)
[1] snap (IEEE 802.2 SNAP)
[2] arpa (Ethernet_II)
[3] novell-ether (Novell Ethernet_802.3)
Enter the encapsulation type [2]:

Cisco 2620 Specifications

General

Brand	Cisco
Model	2620
Category	Network Router
Language	English