Cisco 2620 User Manual

3-13
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-04
Chapter3 Configuring with the Command-Line Interface
Configuring ISDN BRI WAN Interface Cards
Table3-7 ISDN Provisioning by Switch Type
Switch Type Provisioning
5ESS Custom BRI For data only:
2 B channels for data
Point to point
Terminal type = E
1 directory number (DN) assigned by service provider
MTERM = 1
Request delivery of calling line ID on Centrex lines
Set speed for ISDN calls to 56 kbps outside local exchange
5ESS Custom BRI For voice and data:
(Use these values only if you have an ISDN telephone connected.)|
2 B channels for voice or data
Multipoint
Terminal type = D
2 directory numbers assigned by service provider
2 service profile (SPIDs) required, assigned by service provider
MTERM = 2
Number of cal appearances = 1
Display = No
Ringing/idle call appearances = 1
Autohold = no
Onetouch = no
Request delivery of calling line ID on Centrex lines
Set speed for ISDN calls to 56 kbps outside local exchange
Directory number 1 can hunt to directory number 2
5ESS National ISDN (NI-1) BRI Terminal type = A
2 B channels for voice or data
2 directory numbers assigned by service provider
2 SPIDs required, assigned by service provider
Set speed for ISDN calls to 56 kbps outside local exchange
Directory number 1 can hunt to directory number 2
DMS-100 BRI 2 B channels for voice or data
2 directory numbers assigned by service provider
2 SPIDs required, assigned by service provider
Functional signaling
Dynamic terminal endpoint identifier (TEI) assignment
Maximum number of keys = 64
Release key = no, or key number = no
Ringing indicator = no
EKTS = no
PVC = 2
Request delivery of calling line ID on Centrex lines
Set speed for ISDN calls to 56 kbps outside local exchange
Directory number 1 can hunt to directory number 2

Cisco 2620 Specifications

General

Brand	Cisco
Model	2620
Category	Network Router
Language	English