3-12
Cisco 4400 Series Hardware Installation Guide
OL-27644-01
Chapter 3 Installing and Connecting the Router
Connecting Power
Figure 3-7 Chassis Ground Connection on the Cisco ISR 4451-X Chassis
Step 4
Connect the other end of the ground wire to a known reliable earth ground point at your site.
Connecting Power
This section explains how to connect AC power to Cisco ISR 4451-Xs.
Warning
Read the installation instructions before connecting the system to the power source.
Statement 1004
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Note The installation must comply with all required electrical codes applicable at the installation site.
250915
To Next Page
Loading...
