7-36
Firepower 7000 and 8000 Series Installation Guide
Chapter 7 Hardware Specifications
Firepower 8000 Series Devices
Dual-Port 40GBASE-SR4 Fiber Configurable Bypass NetMod
The dual-port 40GBASE-SR4 fiber configurable bypass NetMod contains two fiber ports and link,
activity, and bypass LEDs.
You can use the 40G NetMod in the following 8000 Series models:
• Firepower 8270 and 8290
• Firepower and AMP 8360, 8370 and 8390
• Firepower 8250 and 8260 (must be 40G-capable)
Optical interface Multimode Single mode only
Operating distance 840-860 nm
(850 nm typical)
85 ft (26 m) to 108 ft (33 m) for 62.5
µm/125 µm fiber (modal BW 160 to 200
respectively)
216 ft (66 m) to 269 ft (82 m) for 50
µm/125 µm fiber (modal BW 400 to 500
respectively)
Distances to 980 ft (300 m) are available
with higher quality (OM3) fiber.
Minimum distances (all):
6ft (2 m)
1270-1355 nm
(1310 nm typical)
6 ft to 6.2 miles (2 m to 10 km) for
9 µm/125 µm fiber
Transmitter wavelength 840-860 nm
(850 nm typical)
1270-1355 nm
(1310 nm typical)
Maximum average launch power -1 dBm -0.5 dBm
Minimum average launch power -7.3 dBm -8.2 dBm
Maximum average power at receiver -1 dBm -0.5 dBm
Receiver sensitivity -9.9 dBm -14.4 dBm
Table 7-51 10GBASE MMSR and SMLR NetMod Optical Parameters (continued)
Parameter 10GBASE MMSR 10GBASE SMLR
To Next Page
Loading...
