7-5
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12457-01
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
Table 7-2 Status Messages on the Cisco Unified IP Phone 7931G
Message Description Possible Explanation and Action
BootP server used The phone obtained its IP
address from a BootP server
rather than a DHCP server.
None. This message is informational only.
CFG file not found The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the
Cisco Unified Communications Manager
database. If the phone has not been added to
the Cisco Unified Communications Manager
database, the TFTP server generates a
CFG
File Not Found
response.
• Phone is not registered with
Cisco Unified Communications
Manager.
You must manually add the phone to
Cisco Unified Communications Manager
if you are not allowing phones to
auto-register. See the “Adding Phones
with Cisco Unified Communications
Manager Administration” section on
page 2-14 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
“Network Configuration Menu” section
on page 4-7 for details on assigning a
TFTP server.
CFG TFTP Size Error The configuration file is too
large for file system on the
phone.
Power cycle the phone.
To Next Page
Loading...
