Chapter 8 Monitoring the Cisco Unified IP Phone Remotely
Accessing the Web Page for a Phone
8-2
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12457-01
• Network Statistics, page 8-12
• Device Logs, page 8-14
• Streaming Statistics, page 8-15
Accessing the Web Page for a Phone
To access the web page for a Cisco Unified IP Phone, perform these steps.
Note If you cannot access the web page, it may be disabled. See the “Disabling and
Enabling Web Page Access” section on page 8-4 for more information.
Procedure
Step 1 Obtain the IP address of the Cisco Unified IP Phone using one of these methods:
• Search for the phone in Cisco Unified Communications Manager
Administration by choosing Device > Phone. Phones registered with
Cisco Unified Communications Manager display the IP address at the top of
the Phone Configuration web page.
• On the phone, take either of these actions:
–
If the phone is registered with Cisco Unified Communications Manager,
press the Application Menu button, choose Settings >
Network Configuration, and then scroll to the IP Address option.
By default, the Application Menu button is line button 24 (the top left
line button).
–
If the phone is not registered with Cisco Unified Communications
Manager, press the Settings softkey, choose Network Configuration,
and then scroll to the IP Address option.
The Settings softkey appears only when the phone is not registered.
Step 2 Open a web browser and enter the following URL, where IP_address is the IP
address of the Cisco Unified IP Phone:
http://IP_address
To Next Page
Loading...
